Advertisement
Quick Links
Advertisement
Related Manuals for BRABUS 1300 R
Summary of Contents for BRABUS 1300 R
- Page 1 SETUP INSTRUCTIONS 2022 Art. no. 3214662en...
- Page 3 KTM applies quality assurance processes that lead to the highest possible product quality as defined in the ISO 9001 international quality management standard. Issued by: TÜV‑Management Service KTM Sportmotorcycle GmbH Stallhofnerstraße 3 5230 Mattighofen, Austria This document is valid for the following models: BRABUS 1300 R (F9999V4, F9999V5) *3214662en* 3214662en 02/2022...
-
Page 4: Means Of Representation
1 MEANS OF REPRESENTATION Symbols used The meaning of specific symbols is described below. Indicates an expected reaction (e.g. of a work step or a function). Indicates an unexpected reaction (e.g. of a work step or a function). Indicates a page reference (more information is provided on the specified page). Indicates information with more details or tips. - Page 5 SETUP 2 Transport mode This vehicle was blocked for transport in the software. To operate the vehicle, the vehicle electronics must be enabled. This process is conducted during initial setup in KTM Dealer.net. Enabling ensures that the initial setup in KTM Dealer.net is docu- mented.
-
Page 6: Tighten Screw
2 SETUP – Remove the handlebar clamp screws – Take off the handlebar clamp. S05295-10 – Position the handlebar. The markings of the handlebar scale are located centrally between the handlebar clamp. – Position the handlebar clamp. Mount and tighten the screws evenly. -
Page 7: Remove Cover
SETUP 2 – Remove the front rider's seat. ( p. 6) – Remove the black ignition key and KEYCODECARD and keep in a safe place for the handover. – Remove cover – Plug in the connector of starter relay – Mount the cover. - Page 8 3 WORK Removing the front rider's seat – Pull off back cushion toward the front. – Unlock the front rider's seat with loop – Lift the rear of the front rider's seat. S05188-10 – Disconnect plug-in connector of the seat heating. –...
- Page 9 WORK 3 Removing the 12-V battery Warning Risk of injury Battery acid and battery gases cause serious chemical burns. – Keep 12 V batteries out of the reach of children. – Wear suitable protective clothing and safety glasses. – Avoid contact with battery acid and battery gases. –...
- Page 10 3 WORK Installing the 12-V battery Warning Risk of injury Battery acid and battery gases cause serious chemical burns. – Keep 12 V batteries out of the reach of children. – Wear suitable protective clothing and safety glasses. – Avoid contact with battery acid and battery gases. –...
- Page 11 WORK 3 Disconnecting the negative cable of the 12-V battery Warning Risk of injury Battery acid and battery gases cause serious chemical burns. – Keep 12 V batteries out of the reach of children. – Wear suitable protective clothing and safety glasses. –...
- Page 12 3 WORK Caution Danger of accidents Electronic components and safety devices will be damaged if the 12-V battery is dis- charged or missing. If the 12-V battery is discharged or defective, malfunctions in the vehicle electronics can occur, espe- cially when starting. –...
- Page 13 WORK 3 Note Environmental hazard Hazardous substances cause environmental damage. – Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regulations. Info Even when there is no load on the 12-V battery, it discharges steadily each day. The charging level and the method of charging are very important for the service life of the 12-V battery.
- Page 14 3 WORK Refueling Danger Fire hazard Fuel is highly flammable. The fuel in the fuel tank expands when warm and can escape if overfilled. – Do not fuel the vehicle in the vicinity of open flames or lit cigarettes. – Switch off the engine for refueling. –...
- Page 15 WORK 3 Opening fuel tank filler cap Danger Fire hazard Fuel is highly flammable. The fuel in the fuel tank expands when warm and can escape if overfilled. – Do not fuel the vehicle in the vicinity of open flames or lit cigarettes. –...
- Page 16 3 WORK 3.10 Closing the fuel tank filler cap Warning Fire hazard Fuel is highly flammable, toxic and a health hazard. – Check that the fuel tank filler cap is locked cor- rectly after closing. – Change your clothing if fuel spills on them. –...
- Page 17 WORK 3 The year next to Date flashes. – Press the UP or DOWN button until the current year is set. – Press the SET button. The date is stored.
-
Page 18: Technical Data
4 TECHNICAL DATA Chassis tightening torques ‑ Brake fluid reservoir for front brake 1 Nm (0.7 lbf ft) cover ‑ Brake fluid reservoir for rear brake 3.5 Nm (2.58 lbf ft) cover Remaining screws, chassis EJOT PT ® K50x12 1 Nm (0.7 lbf ft) Remaining screws, chassis EJOT PT ®... - Page 19 TECHNICAL DATA 4 Screw, license plate holder on 8 Nm (5.9 lbf ft) lower rear panel Screw, radiator fan cover 3.5 Nm (2.58 lbf ft) Screw, rear turn signal bracket 3.5 Nm (2.58 lbf ft) Screw, trim 3.5 Nm (2.58 lbf ft) Screw, wiring harness holding 3.5 Nm (2.58 lbf ft) bracket...
- Page 20 4 TECHNICAL DATA Screw, shift shaft deflector on shift 18 Nm (13.3 lbf ft) shaft Loctite ® 243™ Screw, steering damper bracket on 8 Nm (5.9 lbf ft) frame Loctite ® 243™ Screw, step plate for foot brake 10 Nm (7.4 lbf ft) lever Loctite ®...
- Page 21 TECHNICAL DATA 4 Screw, subframe 35 Nm (25.8 lbf ft) Loctite ® 243™ Screw, subframe 28 Nm (20.7 lbf ft) Loctite ® 243™ Screw, subframe brace 25 Nm (18.4 lbf ft) Loctite ® 243™ Screw, subframe metal flange 14 Nm (10.3 lbf ft) Loctite ®...
- Page 22 5 SUBSTANCES Super unleaded (ROZ 95) Standard/classification – DIN EN 228 (ROZ 95) Guideline – Only use super unleaded fuel that matches or is equivalent to the specified standard. – Fuel with an ethanol content of up to 10% (E10 fuel) is safe to use. Info Do not use fuel containing methanol (e.g., M15, M85, M100) or more than 10% ethanol (e.g., E15, E25, E85, E100).
- Page 23 *3214662en* 3214662en 02/2022 KTM Sportmotorcycle GmbH 5230 Mattighofen/Austria Photo: BRABUS/Mitterbauer/KISKA/KTM KTM.COM...