Lindab Architect Luna Service & Maintenance page 3

li ndab | f o r a be tte r cli mat e
Architect Service & maintenance
1.5.1 Before installation
Notice! The connection pipes are internally soft-welded, therefore it is not allowed to
solder the beam to the pipes. For other than Lindab fittings and valves, please consult
the installation guide for the specific fitting for further details on proper installation.Both
inlet- and return pipes are covered by a plastic or rubber protection cover, which must be
removed before installation.
After removing the protection cover, make sure that the pipe is intact and undamaged,
especially at the pipe end, as even small dents and scratches potentially pose a risk of
leakage in the system.
Eventually deburr the pipe ends on the inside and the outside, using a deburring tool
before installation.
Always remember to do a pressure test after assembly of the pipe work.
Lindab reserves the right to make changes without prior notice 3
2022-10-18