Reset To Factory Defaults - Mi Solar Monitor-ISO SNMP User Manual

Solar Monitor

3. Reset to factory defaults

press the switch, keep it pressed, apply power to the unit, wait 10 sec, release
the switch, unit will be reachable on the default IP 192.168.1.2
Username:
Default password:
4. OPTIONAL 5 WAY RELAY MODULE
The 5 Relay expansion module connects to the Solar Monitor via a 10way ribbon
cable supplied with the relay module, Relay's is rated at 10Amps 220Vac.
Relay 1,2,3 can only be toggled to activate for 10sec then return to the off position
again and is used to reset devices.
Relay 4 and 5 can be controlled to the ON or OFF position by the user and will keep
the selected position until changed by the user.
The status of all 5 relays is displayed on the home page of the unit by means of
green dots.
In the "Relay" control page the user can assign names to the relays to help
remember what is connected to the relays at the remote site.
-ISO
SNMP
admin
admin
– reset switch on the left side of the LAN port,
Mi
6 | P a g e