Seecode 20301 Instruction Manual page 7

Technical data
Product name: Callus remover
Charging voltage: 5 V
Charging current: 1 A
Battery: 1000mAh polymer lithium-ion battery
How to use the callus remover
Fully charge the callus remover before using it for the first time.
Remove the protective film from the pre-mounted abrasive roller.
Press the on/off switch, the working indicator lights up blue, the grinding head starts to rotate.
There are 2 speeds available, which can be changed by pressing the on/off switch. The blue LED
light stands for a normal speed, the red LED light for a fast speed.
To switch off the unit, press the on/off switch again after the fast speed and the LED light goes
out.
Sequence of switching operations: switching on at normal speed, switching on at fast speed,
switching off.
Changing the grinding head
Disassembly
Always switch off the unit before changing it.
Remove the head section. Press the side release button of the grinding head as shown in the
illustration and remove the grinding head.
Mounting
Insert a holder of the grinding head into the square groove on the handle.
Engage the counterpart of the grinding head in the opposite square groove by pressing the
release button until you can hear a clear engagement noise.
Application
When the grinding head rotates, carefully approach the skin area with the cornea and apply light
pressure. The application is not unpleasant or harmful to the skin. Go slowly over all affected
areas of skin with the abrasive head. You can also use the rollers wet for foot cleaning and more
comfort.
If the callus removal does feel uncomfortable, please reduce the pressure on that area or stop the
process and examine the skin area.
After use, please recharge the device in good time. The performance of the battery may decrease
if it is not used for a long period of time and is not sufficiently charged.
Cleaning the callus remover
After use, please always empty the skin particle
container, particle build-up can affect the effecti-
veness of further particle shots.
As shown in the illustration, remove the head
section and briefly rinse only the abrasive head
under running water. Please do not use deter-
gents to clean the abrasive head. The unit is
water resistant. Allow the unit to dry thoroughly
afterwards.