C. Guide to connecting WIFI
If you want to connect your Raspberry Pi to the internet or local network then you will need
to follow these steps:
1. WiFi connections can be made via the network icon at the right-hand end of the menu
bar. left-clicking this icon will bring up a list of available WiFi networks.
2. If no networks are found, it will show the message "No APs found - scanning...": just wait
a few seconds without closing the menu, and it should find your network.
3. The icons on the right show whether a network is secured or not, and its signal strength.
Click the network that you want to connect to. If it's secured, a dialogue box will appear
prompting you to enter the network key.
4. Enter the key and press OK, then wait a couple of seconds. The network icon will flash
briefly to show that a connection is being made. Once it's ready, the icon stops flashing
and shows the signal strength.
16
www.uctronics.com