Installation M2.5*4 countersunk screw 3. Please use M2.5*4 screws to fix the enclosure. M2.5*4 countersunk screw 4. Rear schematic...
Page 8
Installation M2.5 nut 5. Please use M2.5 nuts to fix the OLED display on the mounting bracket. It is pre-installed, so this step can be ignored. 6. Put the rubber washer on the switch, then let the switch go through the hole on the mounting plate and fix it with the silver nut.
Page 9
Installation M2.5 nut 7. Now you just need to fix the Raspberry Pi and PoE HAT with M2.5 nuts and M2.5*18 standoffs. Please note the Raspberry Pi motherboard is not included. M2.5*12 countersunk screw 8. Then, please use M2.5*12 silver screws to fix the RPi from the bottom of the mounting plate.
Installation The connection way is the only one. 9. Please connect the power button, OLED screen, and SD card according to the diagram. Wire for Screen Wire for Power Switch SD card Adapter SD card Adapter M4 thumbscrew 10. Finally, insert the 5 installed modules and fix them with M4 thumbscrews.
Page 11
Then save and exit. Reboot to verify that the screen comes up on boot! NOTE: This script is only available for Raspbian. For more scripts, check out our GitHub page: https://github.com/UCTRONICS/U6143_ssd1306, and we will keep online up-to-date continuously for other OSs.
Page 12
CONTACT US If any problem, feel free to contact us. Website: www.uctronics.com Email: support@uctronics.com metal...