Table of Contents
Advertisement
Operating Instructions
4. Safety
The ProGap S was designed, built and tested to be safe and was shipped in safe condition.
Nevertheless persons or objects may be endangered by components of the system if these are operated in an
inexpert manner. Therefore the operational instructions must be read completely and the safety notes must be
followed.
In case of inexpert or irregular use, the manufacturer will refuse any liability or guarantee.
4.1 Regular Use
Only original spare parts and accessories of SWR engineering must be used.
•
4.2 Identification of Dangers
Possible dangers when using the sensor are marked in the operating instructions.
•
4.3
Operational Safety
The microwave barrier must be installed by trained and authorised personnel only.
•
In case of maintenance-work on the pipe or on components of the ProGap S-sensor, make sure that the
•
piping is in unpressurized condition.
Switch off the power supply for all maintenance, cleaning or inspection works on the tubes or on
•
components of the ProGap S.
Before hot work the microwave barrier must be removed from the installation place.
•
The components and electrical connections must be checked for damages regularly. If a damage is
•
found, it is to be repaired before further operation of the instruments.
4.4 Technical Progress
The manufacturer reserves the right to adapt technical data to the technical progress without particular
•
advance notice. If you have any questions, SWR engineering will be pleased to inform you on possible
changes and extensions of the operating instructions.
7
Advertisement
Table of Contents
