Haas TL-1 Operator's page 21

Messages
The Message Display can be selected by pressing the Alarm/Mesgs button
twice. This is an operator message display and has no other effect on opera-
tion of the control. Use the keypad to enter the messages. The cancel and
space keys can be used to remove existing messages and the Delete button
can be used to remove an entire line. Data is automatically stored and main-
tained even in a power-off state. The message display page will come up dur-
ing power-up if there are no new alarms present.
5. m
aintenance
l
uBrication
The linear guides and ball screws are manually lubricated. There is a grease
fitting on the Z axis saddle which is plumbed to lubricate the four trucks. The
Z-axis ball screw is lubricated through a grease fitting on the ball nut. This is
accessible from the left side of the machine. The Z-axis rack should be lubri-
cated with light oil to prevent rust.
Two grease fittings are located on the X-axis cross-slide. One is for the ball
screw and the other is plumbed to the four trucks.
The optional tailstock has one grease fitting on it to lubricate the quill.
To insure proper lubrication the X and Z axes should be cycled daily and lubri-
cated weekly, using a general-purpose lithium grease.
Lubricate with a grease gun until visible grease comes out of the ball-nut and
linear guide trucks
96-0112 Rev W
July 2010
- t l
oolroom athe
5
1
2
4
5
3
6
19