Haas TL-1 Operator's page 18

MANUAL SETUP TURN & FACE
TOOL NUMBER
1
WORK OFFSET
54
Z START PT
0.0000 in
OUTSIDE DIA.
0.0000 in
RAPID
Tool Number – Enter tool to be used. Note that tool offsets must be set before
automatic operation is started.
Work Offset – Enter work offset to be used (see the Operator's manual for
more information on work offsets).
Z Start Pt – Enter the Z axis starting point. New starting points can be
generated by entering a positive or negative value. This value will shift the
starting point the amount in Z Start Point from the work offset.
Outside Dia. – Enter the current diameter of the work piece. Manually measure
the diameter.
Dia. to Cut – Enter the finished diameter.
Z Dimension – Enter the Z axis dimension of the part from the Z Start Point.
Depth of Cut – Enter the depth of cut for each pass of the stock removal.
Feed Per Rev – Enter feed per revolution. This is the distance the tool moves
for each spindle revolution.
MAX RPM – Enter the maximum spindle turning speed.
SFM – Enter the Surface Feed per Minute.
Fillet Radii – Enter the corner fillet radii or enter '0' for none.
Tool Nose – Enter the tool nose radius.
Advanced Users
Some operations may need additional settings modified to create required
groove. Setting numbers are: 22, 28, 72, 73, 86, 95, 96, 99. See definition of
setting in Operator's Manual.
In Graphics mode tool paths are inverted; off centerline cuts show tool
approaching from top of screen. The control interprets values and dis-
plays them as a customary CNC lathe, which has the tool on the other
side of the part.
16
CHAMFER & RADIUS
DIA. TO CUT
0.0000 in
Z DIMENSION
0.0000 in
DEPTH OF CUT FILLET RADII
0.0000 in
FEED PER REV
0.0000 in
FEED OD TURN ID TURN
DRILL & TAP THREADING THREAD RE-CUT
MAX RPM
1000
SFM
500
0.0000 in
Press <CYCLE START> to run
TOOL NOSE
in MDI or <F4> to record
0.0000 in
output to a program
FACE PROFILE
GROOVING
96-0112 Rev W
July 2010