Ips R Ecorder - Haas TL-1 Operator's

ipS r
ecorder
The IPS recorder provides a simple method to place G-code generated by IPS
into new or existing programs.
1. To access IPS, press MDI/DNC, then PROGRM/CONVRS. Refer to your
Intuitive Programming System Operator Manual (ES0609 Lathe) for more
information on using IPS.
2. When the recorder is available, a message appears in red in the lower right
corner of the tab:
MANUAL
TOOL NUMBER
WORK OFFSET
Z START PT
OUTSIDE DIA.
RAPID
3. Press F4 to access the IPS recorder menu. Choose menu option 1 or 2 to
continue, or option 3 to cancel and return to IPS. F4 can also be used to
return to IPS from any point within IPS recorder.
EED PER REV
Menu Option 1: Select / Create Program
Select this menu option to choose an existing program in memory or to create
a new program into which the G-code will be inserted.
96-0112 Rev W
July 2010
SETUP TURN & FACE CHAMFER AND RADIUS
DIA TO CUT
1 0.0000 in
Z DIMENSION
54 0.0000 in
DEPTH OF CUT
0.0000 in 0.0500 in
FEED PER REV
0.0000 in 0.0100 in
FEED OD TURN ID TURN
0.0500 in
IPS RECORDER
TOOL NOSE
1. ) Select / Create Program
0.0100 in
2. ) Output to current program
3. ) Cancel
IPS Recorder Menu
DRILL & TAP
MAX RPM
1000
SFM
200
FILLET RADII
0.0000 in
TOOL NOSE
0.0315 in
FACE PROFILE
0.0000 in
0.0315 in
IPS Recorder Menu
THREADING GROOVING VQC
Press <CYCLE START>
to run in MDI or <F4>
to record output to a
program.
F4 CANCEL
Press <CYCL
to run in MDI
to record outp
program.
17