Anual Ode; Osition - Haas TL-1 Operator's

5. Surface grind or mill shims to correct runout, as close to 0.0000" as possible
at tool #1.
6. When runout is eliminated, repeat the base squaring procedure above.
Torque the mounting bolts to 200 ft-lbs.
m m
anual ode
Select Manual Mode by moving highlighted tab to "Manual Mode" and press
Write/Enter.
X and Z Axes
This mode positions the cutting tool using the hand wheels or the pendant jog
handle. When the lathe is initially powered up, the handwheels position the
cutting tools and "XZ MAN" is displayed at the bottom of the pendant screen.
To change position control to pendant jog handle, press Shift key and X+ or
X- to control X-axis or Shift key and Z+ or Z- to control Z-axis. To return to hand
wheel control, press the Shift key and X+, X-, Z+ or Z- again. Note that the
sequence of using "Shift" and selecting an axis will work on most screens.
Spindle
Spindle is commanded by entering value for the spindle speed and pressing
either FWD or REV. The spindle speed override keys ( +/- 10%) can be used to
adjust commanded speed. This also works on most screens.
m p
achine

oSition

Machine coordinates are shown on right side of display screen. Four coordi-
nate modes are accessed by pressing the POSIT button, and can be scrolled
through using Page Up and Page Down. These are:
POS-OPER – This is for the operator/setup person to use as desired, and is
not used by the control for any positioning functions. In JOG mode, and with
this display selected, select an axis (press X- or X+ for the X-axis or Z- or Z+
for the Z-axis). Press the ORIGIN button to set the display to zero. The (OPER-
ATOR) display will then show position relative to this newly reset zero position.
POS-WORK – Shows how far the tool is away from the X and Z zero of the
programmed part. On power up, it displays the value in work offset G54 auto-
matically. The machine uses this coordinate system to run the part.
POS-MACH – Machine coordinate system automatically set on power up and
the first ZERO RET. It cannot be changed by the operator or any work coordi-
nate systems, and always shows distance from machine zero.
POS-TO GO – An incremental display that shows the travel distance remaining
before the axes stop, during a programmed movement.
14 96-0112 Rev W
July 2010