Chicco 06867 M Instructions Manual page 45

before using it again.
• After three minutes without being used and with no heating cycle set, the device will switch off
automatically.
• Do not touch the bottle warmer with wet or damp hands.
• Do not touch the bottle warmer if it is accidentally dropped into water; unplug it immediately and
do not use it again. Contact trained, qualified technical personnel or Artsana S.p.A.
• At the end of the sterilisation cycle the objects inside the device are very hot. Always be extremely
careful and allow the items to cool before handling them.
• In the event of a power blackout the disinfection cycle will be cut off and disinfection may there-
fore be insufficient.
• Do not insert objects that are not suitable for hot disinfection.
• In the event of a fault and/or malfunction of the bottle warmer, switch it off and unplug it from
the power socket, do not try to repair and/or service it, but contact only competent and qualified
technical personnel or Artsana S.p.A.
• Only contact a qualified technician or Artsana S.p.A. for repairs. Incorrect repairs by unqualified
personnel may cause damage or injury to users.
• If you have any doubts on the explanations provided in this instruction manual, please contact
your dealer or Artsana S.p.A.
• When disposing of the packaging of the accessories subject to wear or of the device itself, separate
collection must be carried out with reference to the specific legislation in force in each country.
DEVICE CLEANING AND MAINTENANCE
At the end of each use, unplug the bottle warmer power cable (c) from the power socket. Leave the
bottle warmer to cool down completely and after removing any residual water in the tank, dry it
thoroughly before storing it in a clean and dry place.
DESCALING
During normal use, limescale deposits may form in the heating tank, which can reduce the perfor-
mance of the device and damage it in the long term. The product will signal the presence of scales
and the need for descaling.
1. Check whether the button/icon used to select the descaling option (p) is on or off. If the white
indicator light for the button/icon is on the product needs descaling.
2. Switch off the device and allow it to cool completely.
3. To remove limescale from the bottom of the tank, pour a 200 ml solution with equal parts water
and white wine vinegar into the tank and leave it to act for at least one night.
Never switch the bottle warmer on while the water-white vinegar solution is in the tank.
4. After the descaling cycle, rinse the inside of the tank thoroughly, clean and dry all the internal
and external parts carefully.
5. Complete a blank heating cycle with 140 ml of water in the tank. Set the programme to rapid
heating (f1), medium capacity feeding bottle (g2) and refrigerator temperature (h2).
6. Switch off the device, allow it to cool completely, then remove the remaining water and dry the
device completely.
Use a cloth partially moistened with water to clean the external parts of the bottle warmer.
WARNING
Descaling operations should be carried out every time the descaling button/icon (p) switches on.
In the event of particularly hard water, descaling should be even more frequent.
Do not use tools, abrasive sponges, detergents, alcohol or solvents to carry out cleaning opera-
tions, as they could irreparably damage the bottle warmer and/or its accessories.
7. Before setting a new heating or sterilisation cycle, press and hold the descaling button/icon (p)
until it switches off, about 2 seconds.
45