Advertisement
▓ ▓ ▓ ▓ 測試軟體操作方法
測試軟體操作方法
測試軟體操作方法
測試軟體操作方法
Note:
During the test, The
test is correct.
Because during the test is pressed SEND ALL buttom will be calibrated and stored value for Knob and
fader,Therefore, you must first make knob, fader then the buttom test after test.
Execution Knob and fader test,No matter how many numerical display, are required to rotate to the
end.
STEP 1
STEP 1
STEP 1
STEP 1
Hold down the SEND ALL button, and then insert the USB cable, allowing the machine to enter the
test mode
.
(If the SEND ALL continue to hold, the MUTE 1 ~ MUTE 8 buttons LED displays the
current version of the machine)
STEP 2
STEP 2
STEP 2
STEP 2
Run application software "Midi Device" on the PC
Device selection ADA7, press Create
red
figure indicates that no test；Yellow,
green
shows they in
test；Blue
shows the
Advertisement
