Table of Contents
Advertisement
C. Install the Legs
1. The legs must be used unless the 22CET is installed on a Cleveland Range stand.
2. In order to safely assemble the legs onto the 22CET without damage, follow this procedure:
a. Check that the feet are fully retracted into the legs. Do not tighten. The feet should easily
screw in and out using fingers only.
b. Remove the four foam packing blocks from the upper packing assembly, and position them
on a flat surface (e.g. the floor) as shown in Figure 3-1.
c. Center the steamer on the blocks as shown in Figure 3-1 and 3-2.
d. Screw the four legs into the mounting holes. All four legs must be used for proper installation
of a 22CET.
e. Lift the 22CET off the blocks, and move it to its installed location.
f.
Discard the foam packing blocks.
Figure 3-1
Top View Steamer on Foam
Packing Blocks
D. Position and Level the 22CET
1. Move the 22CET to its installed location.
2. Using a level, adjust the legs of the 22CET or the legs of the Cleveland Range stand until the
22CET is level front-to-back and side-to-side.
E. Install the KleanShield™
a. Never operate a SteamChef Steamer without a properly installed KleanShield™.
b. To install the KleanShield™:
1) Remove the slide pan racks.
2) Place the KleanShield™ into the steamer with the drain to the back of the cooking
compartment and the pipe extension facing down.
3) Set the KleanShield™ in place over the corresponding pipe extending out of the bottom of the
steamer reservoir. See Figure 3-3.
4) Fit the pipe from the KleanShield™ into the corresponding pipe in the bottom of the steamer.
5) KleanShield™ legs must be flush against the bottom of the steamer. See Figure 3-4.
Figure 3-2
Front View Steamer on Foam Blocks
7
Hide quick links:
Advertisement
Table of Contents
