Slide Runner Inspection - Yamaha MM600D Service Manual

4
6
TRACK TENSION ADJUSTMENT/

SLIDE RUNNER INSPECTION

5
SEJ2580
7
SEJ2590
SEJ2600
Track alignment
4 Left adjuster
5 Right adjuster
8 Slide runner 9 Track
0 Track metal A Gap
c. Adjust the track deflection until the specified
amount is obtained.
Track deflection
4 Left adjuster
5 Right adjuster
CAUTION:
The adjusters should be turned an equal amount.
•
Recheck the alignment and deflection. If nec-
essary, repeat steps (a) to (c) until the speci-
fied amount is obtained.
•
Tighten the rear axle nut.
Nut (rear axle):
75 Nm (7.5 m • kg, 54 ft • lb)
SLIDE RUNNER INSPECTION
1. Inspect:
•
Slide runner 1
Cracks/damage/wear → Replace.
2. Measure:
•
Slide runner thickness a
Out of specification → Replace.
Slide runner wear limit a:
10 mm (0.39 in)
2-27
INSP
ADJ
6 Shifted 7 Shifted
to right to left
Turn out Turn in
Turn in Turn out
B Forward
More than Less than
specified
specified
Turn in Turn out
Turn out
Turn in