Displaying The Dme Information Window; Using The Generic Timer; Changing The Temperature Display Units - Garmin G1000 NXi Reference Manual

DISPLAYING THE DME INFORMATION WINDOW

1) Press the PFD Opt Softkey.
2) Press the DME Softkey to display the DME Information Window above the
BRG1 Information Window.
3) To remove the DME Information Window, press the DME Softkey again.

USING THE GENERIC TIMER

1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to select the timer field (HH:MM:SS).
3) Use the FMS Knob to enter the desired time.
4) Press the ENT Key. The Up/Dn field is now highlighted.
5) Turn the small FMS Knob to display the Up/Dn Window.
6) Turn the small FMS Knob to select 'Up' or 'Dn'.
7) Press the ENT Key. 'Start?' is now highlighted.
8) Press the ENT Key to start the timer. The field changes to 'Stop?'. If the
timer is counting down, it will start counting up after reaching zero.
9) To stop the timer, press the ENT Key with 'Stop?' highlighted. The field
changes to 'Reset?'.
10) To reset the timer, press the ENT Key with 'Reset?' highlighted. The field
changes back to 'Start?' and the digits are reset.
11) To remove the window, press the CLR Key or the TMR/REF Softkey.

CHANGING THE TEMPERATURE DISPLAY UNITS

1) Select the 'Aux - System Setup 1' Page.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the Temperature units field.
4) Turn the small FMS Knob to highlight 'CelsiusºC' or 'Fahrenheit(ºF) and
press the ENT Key.
5) Press the FMS Knob to deactivate the cursor.
190-02178-02 Rev. A Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
Flight Instruments
7