5.3 Wiring
Note: Before insert input power wire, please cut silicon sealed
loop as required to maintain IP65.
The power supply cables go through the input inlet at the
charger's bottom, and connect to the corresponding PE, L and N
terminals on the breaker inside charger.
1. Remove a length of 40mm of the cable jacket and strip the wire
insulation to a length of 8~15mm.
2. Crimp the terminals as shown in the figure below.
3. Distinguish different input wires of three-phase and
single-phase, then insert the wire into the corresponding wire
slot.
Note: If your charger is with PEN-protection function, please
follow same wiring as shown overleaf.
15