Table of Contents
Advertisement
4.2 Safety of Installation
Installation Notice
Electrical devices should only be installed, operated, and
maintained by a qualified professional. The manufacturer does
not assume responsibility for any consequences arising out of
the use of this device. A qualified person is one who has certified
skills and knowledge related to the construction, installation and
operation of this type of electrical device and who has received
safety training to recognize and avoid the hazards involved.
All applicable local, regional, and national regulations must be
applied when installing, repairing and maintaining this device.
Installation Inspection
Ensure the charger's location allows good operational access for
normal use and repair & maintenance.
Check that the AC input components within the premise's pow-
er supply are correctly fitted with the required protection items
prior to installation of the charger.
4.3 Installation Process
Wall-mount Installation: single-phase
1. Based on the profile of the attached installation board, drill 3 x
Φ 6*35 mm holes on the wall, and insert the expansion pipe.
2. Lock the 2 x M4*32mm self-tapping screws into the expansion
pipe, leaving a 5mm space, between the screw head to the wall.
3. Open the upper cover of charger, hang it on the 2x M4*32 mm
screws, lock it into the bottom M4*32 mm self-tapping screw
and then cover the sealing cap.
10
Advertisement
Table of Contents
