Corally Kronos XTR XP 6S Quick Start User Manual page 9

INSTALL ELECTRONICS
3
MOTOR INSTALLATION
Connect the motor to the controller as described in
the controller manual.
Apply some Corally Screw Fix - Blue
# C-13094
GEAR MESH ADJUSTMENT
If the gear mesh is not correct, you wear out the spur gear prematurely, the transmission will make noise, give unnecessary load on the
motor (higher consumption, heating of the transmission).
PAPER STRIP 1x8cm
1. Loosen the screws.
2. Insert the paper strip.
3. Push the motor against the spur gear.
IMPORTANT : To adjust the space between the
pinion and the spur gear, refer to "Gear Mesh
Adjustment" section.
4. Turn the spur gear to run the paper through the
teeth.
Stop when the paper is in the middle.
Make sure that the motor pinion is against the
spur gear..
5. Maintain and tighten the fixing screws.
9