How To Clean And Disinfect - Accucold AIWD160 User Manual

How to Clean and Disinfect

The dispenser should be cleaned and disinfected at least twice a year. More frequent cleaning and
disinfection may be required.
Please observe the following points.
•
Do not use ammonia-type detergents to prevent personal injury or damage to the ice maker.
•
Disinfection and cleaning should be handled according to the instructions provided.
•
Always wear protective eyewear and waterproof gloves to prevent skin or eye contact with water and
disinfectant.
•
After cleaning and disinfection, do not use ice made from cleaning agent and disinfectant. Be careful that no
disinfectant remains in the dispenser and any parts in the reservoir.
Washing Use a scale remover that is not harmful to the human body by diluting with water, and add
solution more if necessary.
It is important to use the diluted cleaning solution immediately for safety and maximum
effect.
Washing 1) Shut off the water supply by locking the valve of the waterline of the ice maker.
procedure 2) Switch the ICE MAKING-OFF-WASH switch to the "WASH" position.
3) The water in the water tank is drained through the evaporator cylinder and washing is
4) Turn the ICE MAKING-OFF-WASH switch to "OFF" position.
5) Remove all ice from the ice maker and reservoir.
6) Pour the wash solution into the wash solution inlet until the evaporator assembly and the
7) Leave the ice maker for 10 minutes before starting the operation. If the water supply
8) As described below, please disassemble and clean the water level sensor (high and low) if
9) Switch the ICE MAKING-OFF-WASH switch to the " ICE MAKING" position to start the
10) Switch the front ICE MAKING-OFF-WASH switch to the "WASH" position, and drain the
11) Switch the ICE MAKING-OFF-WASH switch to the "OFF" position.
12) Open the water supply valve of the ice maker, and switch the ICE MAKING-OFF- WASH
13) When the geared motor is activated, switch the ICE MAKING-OFF-WASH switch to the
14) Turn OFF the power switch and disconnect the power cord from the outlet.
done by this (max. 5 minutes).
water tank are full. (Until the wash solution overflows to the drain box)
hose is clogged, remove it before operation.
it is in bad water condition.
If not, proceed to step 9.
□ Remove the water level sensor from the water tank cover.
□ Clean the level sensor with washing solution.
□ Wash the water level sensor thoroughly with clean water.
□ Fix the level sensor to the correct position.
ice maker. Keep it running until ice making stops.(※ Water supply valve should be
locked so that water is not supplied.)
remaining water in the water tank and evaporator cylinders for 5 minutes.
switch to the " ICE MAKING" position so that water can be supplied to the water tank.
"WASH" position and drain the water (drain is possible for 5 minutes).
22