Mount The Access Point On A Wall - NETGEAR WAX630 User Manual

Insight Managed WiFi 6 AX6000 Tri-band Multi-Gig Access Point Model WAX630

Mount the access point on a wall

CAUTION: Make sure that the wall is not damaged. For example, water damage can
destroy a drywall.
To mount the access point on a wall:
1. Place the mounting plate on the wall.
2. Mark the wall where the mounting holes are.
3. Using a 3/16 in. (4.7mm) drill bit, drill holes in the wall.
4. Tap each anchor into the wall with a soft mallet until the anchors are flush with the
wall.
5. Use the screws to attach the mounting plate to the wall.
Note: Do not insert the screws into the wall without anchors.
6. Connect an Ethernet cable (if you use a PoE++ switch) or both a power adapter and
an Ethernet cable to the access point before you attach the access point to the
mounting plate.
The access point sits flat on the wall when it is mounted.
Mount the Access Point to a Wall
or Ceiling
264 User Manual