NETGEAR WAX630 User Manual page 218

Insight Managed WiFi 6 AX6000 Tri-band Multi-Gig Access Point Model WAX630
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight Cloud Portal or Insight app, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 25.
The Dashboard page displays.
4. Select Management > Configuration > Wireless Bridge.
The page that displays lets you select a WDS profile (WDS 1, WDS 2, WDS 3, or WDS
4).
5. Click the > button to the left of a WDS profile.
The WDS profile page displays.
6. Select the Band 2.4 GHz, 5 GHz Low, or 5 GHz High radio button.
Your selection determines the radio band on which the WDS is established. For
countries that do not support dual-band or tri-band operation, you cannot select
the radio.
7. Select the VAP Enable radio button.
By default, a WDS profile is disabled.
8. Configure the WDS profile settings as described in the following table.
Set up a WiFi Bridge 218 User Manual