Disable Link Aggregation For The Lan 2 Port - NETGEAR WAX630 User Manual

Insight Managed WiFi 6 AX6000 Tri-band Multi-Gig Access Point Model WAX630
The pop-up window closes and your settings are saved. The link aggregation
capability is enabled.

Disable link aggregation for the LAN 2 port

If you enabled link aggregation but no longer need it, you can disable link aggregation
on the access point and return the LAN 2 port to access mode.
Note: Before you disable link aggregation on the access point, disconnect the LAN 2
port on the access point from the Ethernet port on the switch that you used for link
aggregation.
To disable the link aggregation capability on the access point:
1. Launch a web browser from a computer that is connected to the same network as
the access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window displays.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see What to do if you get a browser
security warning on page 44.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight Cloud Portal or Insight app, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 25.
The Dashboard page displays.
4. Select Management > Configuration > System > Advanced > LAG.
The LAG page displays.
5. Select the Disable radio button.
CAUTION: To prevent a network loop, make sure that the access point is connected
to the switch through the LAN 1 port only.
6. Click the Apply button.
A pop-up warning window opens.
Manage the Local Area Network
and IP Settings
148 User Manual