Advertisement
INSTALLER'S GUIDE
1.) From economizer
assembly, pass wire
harness through coil
Grommet. See View A.
1.80"
2.82"
View 'A' Approximate
Mounting Dimensions
4
2.) Continue routing
behind compressor
compartment and into
Blower Compartment.
Location of
Mixed Air Sensor
Figure 3. Main Wire Harness Routing
Mount the Mixed Air
Sensor to the partition
using two (2) sheetmetal
screws. See view A for
approximate positioning
Figure 4. Mount Mixed Air Sensor in Blower Compartment
3.) Pull the two (2) Mixed Air
Sensor wires (with female quick
connects) from the harness and
route down near the Mixed Air
Sensor. Connect to sensor
pigtail wire leads.
4.) Continue Routing the
Remaining Harness
Through the Grommet
and into the Control Box.
See View 'A'
Coil Grommet
View A
Coil Grommet Location
Advertisement
