Replacing The Interior Light Bulb /5; Cleaning And Care /5 - Beko CN228100 Instructions For Use Manual

EN
Warnings!
The fans inside the freezer and fresh food
compartments circulates cold air. Never insert any
object through the guard. Do not allow children to
play with the fresh food andfreezer fan.
Never store products that contain inflammable
propellant gas (eg dispensers, spray cans etc.) or
explosive substances.
Don't cover the shelves with any protective
materials, which may obstruct air circulation.
Do not allow children to play with the appliance or
tamper with the controls.
Do not obstruct the fan guards to ensure that you
obtain the best possible performance from your
appliance. (Item 9 and Item 10)
Warning!
Your appliance is fitted with a circulating fan which
is essential for the performance of the refrigerator.
Please ensure the fans are not blocked (stopped)
or impaired by food or packaging. Blocking
(stopping) or impairing the fan can result in an
increase of the internal freezer temperature
(Thawing).
Replacing the interior light bulb
(Item 11)
In case that the light bulb is out of function it is
easily to replace. First make sure that the
refrigerator / freezer is disconnected from the
power supply by removing the plug. Take a flat
screwdriver and keep it carefully without force into
the left gap between lamp cover and internal
cabinet. Then press the handle of the screwdriver
carefully to the left side until you notice that the left
pin of the cover is disengaged . Repeat this
procedure on the right gap, however now press
the handle of the screwdriver carefully to the right
side. If both sides are loosened the cover can be
removed easily.
Ensure that bulb is screwed securely in the bulb
holder. Plug the appliance into the power supply. If
the light still fails, replace E14 screw-cap type 15
Watt (Max) bulb from your local electrical store
and then fit it. Carefully dispose of the burnt-out
light bulb immediately.
If you have changed the light bulb please fix the
cover again in it's former position. Take care that
the cover snaps-in correctly.
Cleaning and care
1. We recommend that you switch off the
appliance at the socket outlet and pull out the
mains plug before cleaning.
2. Never use any sharp instruments or abrasive
substances, soap, household cleaner, detergent
or wax polish for cleaning.
3. Use luke warm water to clean the cabinet of
the appliance and wipe it dry.
4. Use a damp cloth wrung out in a solution of
one teaspoon of bicarbonate of soda to one pint of
water to clean the interior and wipe it dry.
5. Make sure that no water enters the
temperature control box.
6. If the appliance is not going to be used for a
long period of time, switch it off, remove all food,
clean it and leave the door ajar.
7. We recommend that you polish the metal parts
of the product (i.e. door exterior, cabinet sides)
with a silicone wax (car polish) to protect the high
quality paint finish.
8. Any dust that gathers on the condenser, which
is located at the back of the appliance, should be
removed once a year with a vacuum cleaner.
9. Check door seals regularly to ensure they
areclean and free from food particles.
10. Never:
• Clean the appliance with unsuitable material; eg
petroleum based products.
• Subject it to high temperatures in any way,
• Scour, rub etc., with abrasive material.
11. Removal of dairy cover and door tray :
• To remove the dairy cover, first lift the cover up
by about an inch and pull it off from the side where
there is an opening on the cover.
• To remove a door tray, remove all the contents
and then simply push the door tray upwards from
the base.
12. Make sure that the special plastic container at
the back of the appliance which collects defrost
water is clean at all times. If you want to remove
the tray to clean it, follow the instructions below:
• Switch off at the socket outlet and pull out the
mains plug
• Gently uncrimp the stud on the compressor,
using a pair of pliers, so that the tray can be
removed
• Lift it up.
• Clean and wipe it dry
• Reassemble, reversing the sequence and
operations
13. To remove a drawer, pull it as far as possible,
tilt it upwards and then pull it out completely.
5
Instruction for use