Replacing The Interior Light Bulb; Installation Instructions - Beko LSP4579W Instructions For Use Manual

"IMPORTANT: Make sure that mains
cable is not caught under the appliance
during and after carrying / moving the
appliance, to avoid the mains cable
becoming cut or damaged."
Do not allow children to play with the
appliance or tamper with the controls.
Beko declines to accept any liability
should the instructions not be followed.

Replacing the interior light bulb

To change the Bulb/LED used for
illumination of your refrigerator, call your
Authorised Service. The lamp(s) used in
this appliance is not suitable for
household room illumination. The
intended purpose of this lamp is to
assist the user to place foodstuffs in the
refrigerator in a safe and comfortable
way. The lamps used in this appliance
have to withstand extreme physical
conditions such as temperatures below
-20°C (only chest and upright freezer).

Installation instructions

1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
C
If the ambient temperature is below
0°C, the food in the fridge will freeze. So,
we recommend you don't use the
appliance in such low ambient conditions.
2. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers
From Radiators 300 mm (12")
From Freezers
3. Refer to "Maintenance and cleaning"
section to prepare your appliance for use.
4. Attach 2 plastic wedges as illustrated
below. Plastic wedges are intended to
keep the distance which will ensure the
air circulation between your refrigerator
and the wall.
50 mm (2")
25 mm (1")
9
(The picture is drawn up as a
representation and it is not identical with
your product).
5. A special receptacle is supplied to
store the mains plug during transit. The
receptacle is fixed at the back of the
cabinet, on the side of the compressor
(see diagram). Gently remove the plug
from the receptacle. Never pull the mains
cord, you may damage the appliance. In
the case of transportation, ensure you
locate the plug in the receptacle provided
to avoid transit damage.
6. The appliance should be located on
a smooth surface. The two front feet
can be adjusted as required. To
ensure that, your appliance is standing
upright adjust the two front feet by
turning clockwise or anti-clockwise,
until the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
EN