Panasonic MC-SB30JW147 Operating Instructions Manual page 35

When this happens When this happens
The idling OFF function
is disabled
The exhaust smells of
rubbish
A click sound is heard
when shaking the nozzle
During vacuuming, the
operating sound changes
At startup, the body may
emit a "beep sound (the
"
vacuum cleaner cannot
run at this time)
The dust sensor lamp
fl ashes slowly
(approximately fl ash once
every 3 seconds)
Lamps light even though
no dust has been sucked
(lamps do not go off)
Lamps don't light even
though dust has been
sucked
Lamps don't seem to go
off
Dust sensor lamp, battery
level lamp fl ashing at the
same time
If there is still a problem
after checking
Inspection and handling Inspection and handling
Is the idling OFF function disabled? (P. EN8, EN16)

Is there any dirt or dust on the sensor?

→ Perform maintenance (P. EN12)
Has the vacuum cleaner not been cleaned after inhaling smelly rubbish?

→ If you care about the odor during the re-operation, please remove the rubbish
and perform maintenance (P. EN10 ~ EN11)
Is the dust bin installed correctly? (P. EN10 ~ EN11)

In the automatic mode, the vacuum cleaner automatically adjusts the suction

power according to the amount of the rubbish and causes the operating sound
to fl uctuate. It is not abnormal.
Are the extension wand, nozzle, dust bin, pre fi lter blocked?

→ Perform maintenance (P. EN10 ~ EN13)
Please run again.

Is it at idling OFF?

In the idling OFF mode, the dust sensor lamp fl ashes slowly. (P. EN8)
Is there dust on the dust sensor lamp?

→ Wipe the rubbish, dust, etc. attached to the sensor with a soft, dry cloth
(P. EN12)
In the following cases, the dust sensor lamp may stay lit and will not go out. It is

not abnormal.
• When vacuuming a carpet, etc. (because of the loose fuzz of it)
• When vacuuming bedding such as quilts, blankets, etc. (There may be much
keratin, dander, mite, etc.)
→ After vacuuming, debris such as loose fuzz, keratin, dander, mite, etc. will
gradually decrease, and the lamp will slowly extinguish
You can also set the sensitivity of the sensor to [Easy]
If the lamps are turned on at the same time, the temperature is abnormal.

→ Wait 5 to 30 minutes
When they fl ash at the same time, the dust bin, nozzle, and extension wand

may be blocked.
→ Remove obstructions (P. EN10 ~ EN13)
Do not repair yourself, and please take this product (body, extension wand, fl oor

nozzle, battery charger etc.), together with product warranty registration card to
the original purchase store.
 Please consult with the original dealer.
EN15