Configuring Network Settings; Configuring Tcp/Ip Settings - LevelOne GEMINI FCS-4051 User Manual

6.3 Configuring Network Settings

6.3.1 Configuring TCP/IP Settings

Purpose:
TCP/IP settings must be properly configured before you operate the camera over
network. The camera supports both the IPv4 and IPv6. Both versions may be
configured simultaneously without conflicting to each other, and at least one IP
version should be configured.
Steps:
1. Enter TCP/IP Settings interface:
Configuration > Basic Configuration > Network > TCP/IP
Or Configuration > Advanced Configuration > Network > TCP/IP
2. Configure the basic network settings, including the NIC Type, IPv4 or IPv6
Address, IPv4 or IPv6 Subnet Mask, IPv4 or IPv6 Default Gateway, MTU settings
User Manual of Network Camera
Figure 6-6 TCP/IP Settings
44