Initial Access To The Network Camera; Check Network Settings; Add Password To Prevent Unauthorized Access - LevelOne FCS-3021 User Manual

Update progress
After the upgrade process had been done, you could see the dialog window as below. Please click
on the button "OK" to finish it.
Upgrade Done

Initial Access to the Network Camera

Check Network Settings

The Network Camera can be connected either before or immediately after software installation
onto the Local Area Network. The Administrator should complete the network settings on the
configuration page, including the correct subnet mask and IP address of gateway and DNS. Ask
your network administrator or Internet service provider for the detail information. By default the
Network Camera requires the Administrator to run installation every time it reboots. If the network
settings are to remain unchanged, disable the Install option. Refer to "Network settings" on the
System Configuration page for details. If any setting is entered incorrectly and cannot proceed to
setting up the Network Camera, restore the factory settings following the steps in the
"Troubleshooting" chapter of the Appendix.

Add Password to prevent Unauthorized Access

The default Administrator's password is blank and the Network Camera initially will not ask for any