Leaf Capture Installation Tips - Kodak Leaf Aptus 54S Release Note

Leaf Capture version 11.1.1
Release Notes

Leaf Capture Installation Tips

Updating the Imaging Module Firmware
When you connect your imaging module to the Leaf Capture software, the
following message appears:
Click OK. The imaging module firmware is updated.
This process takes approximately 10 minutes.
Changing Your Mac Operating System
If you change your Mac
for example, if you upgrade from Mac OS 10.4.x (Tiger) to 10.5.x (Leopard), you
must remove your current Leaf Capture 11 version by clicking Uninstall in the
Leaf Capture installer, and then reinstall this Leaf Capture version. This process
ensures compatibility between the Apple
software, and your Leaf imaging module.
Note: If you install Mac operating systems on separate partitions, there is no
need to perform this procedure.
Computer Restarts After Installation
If a driver that is new to your computer is installed during the Leaf Capture
version 11.1.1 software installation, Leaf Capture restarts your computer at the
end of the installation. If you are working in other applications, make sure you
save your work first.
Preferences are Reset After Installation
The installation automatically resets your Leaf Capture preferences.
Note: If you have multiple user accounts, the preferences are reset only for the
user who installs the Leaf Capture software. All other users must manually reset
their preferences:
•
Locate Applications > Leaf Capture 11 > Utilities, and double-click Reset
Preferences.
®
operating system, or if you revert to a previous version,
®
FireWire
®
driver, the Leaf Capture
6