Known Issues - Kodak Leaf Aptus 54S Release Note

Version 11.1.1 including leaf wiview version 1.0.3
Hide thumbs Also See for Leaf Aptus 54S:
Table of Contents

Advertisement

Leaf Capture version 11.1.1
Release Notes

Known Issues

This section lists known problems in the Leaf Capture software and imaging
module. They may be outstanding issues from a previous release, or new
problems. When a problem listed here is resolved, the solution is described in
the Fixed Issues section of the release notes for the next version of the Leaf
Capture software.
Leaf Capture Software Issues
Showing Images in Compare View
In compare view, after showing certain images—for example flagged images—
and then choosing a different show option, the selection is lost.
Misleading Message After Reconnecting After Shooting with a
Custom Lens Calibration File
When you disconnect the imaging module from the Leaf Capture software by
way of clicking disconnect or closing Leaf Capture, but not physically
disconnecting the FireWire cable, the custom lens calibration file is still loaded in
the imaging module.
Upon reconnection, the imaging module searches for the custom lens calibration
file on your computer. If you changed the location or name of the custom lens
calibration file, a message appears warning you that it cannot locate the custom
lens calibration file, and that it will use the default lens calibration file.
However, for as long as the imaging module is not physically disconnected, it
retains the custom lens calibration file in its memory, and continues to use the
custom lens calibration file until you load a new file, or until you physically
disconnect the imaging module by removing the FireWire cable.
Workaround: If you want to use the default lens calibration file, either disconnect
and reconnect by physically removing and replacing the FireWire cable, or
reload the default lens calibration file.
Flagging Images
Auto-save for flags that you apply to images captured in Leaf Capture versions
earlier than version 11.0.2 is not supported.
Workaround: To enable auto-save for flags, resave any images captured in
earlier versions in Leaf Capture version 11.0.2 or later.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents