Download
Share
Print this page
Midea JHSD172 User Manual
  1. Manuals
  2. Brands
  3. Midea Manuals
  4. Freezer
  5. JHSD172
  6. User manual
Midea JHSD172 User Manual

Midea JHSD172 User Manual

Upright freezer
Hide thumbs

Advertisement

Quick Links

Download this manual
UPRIGHT FREEZER
USER'S MANUAL
MODEL: JHSD172

Advertisement

loading
Need help?

Need help?

Do you have a question about the JHSD172 and is the answer not in the manual?

Questions and answers

Related Manuals for Midea JHSD172

Summary of Contents for Midea JHSD172

  • Page 1 UPRIGHT FREEZER USER’S MANUAL MODEL: JHSD172...

  • Page 3: Safety Warnings

    1. SAFETY WARNINGS WARNING― Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING― Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. WARNING―...
  • Page 4 2. INSTALLTION When selec ng a posi on for your unit you should make sure the floor is flat and firm, and the room is well ven lated. Avoid loca ng your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consump on.Extreme cold ambient temperatures may also cause the unit not to perform properly.
  • Page 5 2) Remove the screws fixed the top-hinge with cross-slot screwdriver. 3) Replace the top-hinge and the top-door limit block and the door bearing bush to the other side. Remove the nut with sleeve.Take off the washer then remove the axes to the other side and fixed.
  • Page 6 4) Disassemble the screws fixed the bottom-hinge with Hexagonal socket wrench. Note：the refrigerator-freezer incline angle less 45°. 5) Replace the bo om hinge to the other side then fix it with screws. 6) Set the door right posi on,fix the mid-hinge.
  • Page 7 7) Replace the top-hinge. 8) Set the top door right position,fix the top-hinge and the cover. 9) Replace the leveler to the other side and adjust it to make sure the cabinet level.
  • Page 10 *All images in this instruc on manual are for indica on only; please refer to your individual unit for details.

  • Page 11: Operation

    4. OPERATION 4.1 Switching On Your Unit ◆The temperature selector knob is located on the middle of the upper beam Se ng“Min” ：Less Cool Temperature Se ng“Med” ：Normal Opera on(adequate for most situa ons) Se ng“Max” ：Coolest Temperature ◆During high ambient temperatures e.g. on hot summer days. It may be necessary to set the thermostat to the Coolest se ng(posi on“Max”).This may cause the compressor running con nuously in order to maintain a low temperature in the cabinet.

  • Page 13: Troubleshooting

    7. Trouble shooting The following simple issues can be handled by the user. Please call the after-sale service department if the issues are not settled. Whether the freezer is plugged and connected to power; Inoperation Low voltage; Failure power or tripping circuit Odorous foods should closely wrapped;...
  • Page 14 If it is the outer condenser, the rear wall should be always clean free of dust or any impurities. ◆ The appliance should be located in the coolest area of the room, away from heat producing appliances or heating ducts, and out of the direct sunlight. ◆...