Functional Description And Specifications; Technical Data; Operation - BorMann BCD1330 User Manual

EN

Functional Description and Specifications

The following numbering refers to the illustration of the machine
indicated on pages 2 and 3.
1 Torque selector
2 DC-Connector
3 Rotational Direction Selector switch
4 ON/OFF switch
5 Battery pack
6
Battery charger
7
LED lamp
8 Push-lock button
9 Keyless drill chuck
Before Starting the power tool
Be sure to read the following information before you use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger supplied*. An empty battery pack requires a charging period of approximately 3-5
hours.
2. Only ever use sharp drill bits and screwdriver bits which are suitable for the purpose and in faultless condition.
3. Always check for concealed electric cables and gas and water pipes when drilling and screwing in walls.

Operation

Charging the battery pack (Fig. 2/3)
1. Remove the battery pack (5) from the handle, pressing the push lock buttons (8) downwards to do so.
2. Check that your mains voltage is the same as that marked on the rating plate of the battery charger. Plug the mains plug of
the charger (6) into the mains socket outlet.
3. Push the DC-Connector into the battery pack. The flashing red LED will come on to indicate that the battery pack is being
charged. When the charging process is finished, the red LED will extinguish and green LED will be permanently lit.
The time it takes to fully recharge an empty battery is approximately 3-5 hours.
4. The temperature of the battery pack may rise slightly during the charging operation. This is normal. If the red LED extin-
guishes during charging, the temperature is either above or below the perfect charging temperature. In this case, pull the
plug of the charger and charge the battery in an environment in which the temperature is either warmer or colder.
If the battery pack fails to become charged, please check
• Whether there is voltage at the socket-outlet
• Whether there is proper contact at the charging contacts on the charger.
To ensure that the battery pack provides long service you should take care to recharge it promptly.
You must recharge the battery pack when you notice that the power of the cordless screwdriver drops.
Never fully discharge the battery pack. This will cause the battery pack to develop a defect.
Torque setting (Fig. 4 /1)
The cordless screwdriver is fitted with a mechanical torque selector.
The torque for a specific size of screw is selected with the set-collar (1). The correct torque depends on several factors:
· On the type and hardness of material in question
· On the type and length screws used
· On the requirements needing to be met by the screwed joint.
The clutch disengages with a grating sound to indicate when the set torque is reached.
Important! The tool must be at a standstill when you set the torque with the setting ring.
Drilling (Fig. 5 )
For drilling purposes, move the set-collar to the last step „Drill". In this setting the slip clutch is inactive.
The maximum torque is available in drilling mode.
6
WWW.BORMANNTOOLS.COM
* The accessories illustrated or
described are not included as
standard delivery.

Technical Data

Model BCD1300
Voltage: 12v
Torque:
23Nm
Gears:
2
Battery Type: 1x1,3 Lithium
BCD1330
12v
23Nm
2
2x1,3 Lithium