ECS P6VXM2 Manual page 55

Table of Contents

Advertisement

display speed. If your graphics display card does not support this fea-
ture, you need to disable this item.
OnChip USB
This should be enabled if your system has a USB installed on the sy s-
tem board and you wish to use it.
USB Keyboard Support
Enable this item if you plan to use a keyboard connected through the
USB port in a legacy operating system (such as DOS) that does not
support Plug and Play.
OnChip Sound
When set to Disabled, the onboard audio chip is turned off.
OnChip Modem
This should be enabled if your system has a modem installed on the
system board and you wish to use it.
CPU to PCI Write Buffer
When enabled, up to four words of data can be written to the PCI bus
without interrupting the CPU. When disabled, a write buffer is not used
and the CPU read cycle will not be completed until the PCI bus signals
that it is ready to receive the data. The default setting is Enabled.
PCI Dynamic Bursting
When set to Enabled, every write transaction goes to the write buffer.
Burstable transactions then "burst" on the PCI bus and nonburstable
transaction do not.
PCI Master 0 WS Write
When set to Enabled, writes to the PCI bus are executed with zero wait
states.
PCI Delay Transaction
The chipset has an embedded 32-bit posted write buffer to support de-
lay transactions cycles. Select Enabled to support compliance with PCI
specification version 2.1.
Default: Enabled
Default: Disabled
Default: Auto
Default: Auto
Default: Enabled
Default: Enabled
Default: Enabled
Default: Enabled
49

Advertisement

Table of Contents
loading

Table of Contents