ECS P6VXM2 Manual page 22

JP8: CPU frequency select jumper
This jumper enables you to force the CPU to clock at a higher
frequency than it is rated. Short pins 2 and 3 to force the CPU to
run at a 133 MHz FSB instead of a 100 MHz FSB. We recom-
mend that you leave the jumper on the normal operation setting.
Function
Normal
Force 100 MHz FSB to
run at 133 MHz FSB
Note: The CPU speed is determined by the CPU Host/PCI Clock
speed multiplied by the CPU Clock Ratio. Refer to the Frequency
Control Option in Chapter 3 for more information. Forcing the CPU
to run at a higher clock speed then it was rated for is called over-
clocking and is not recommended.
JP16: Dual color LED header
This header allows the user to install red and green LED indica-
tors to indicate when the computer is in Suspend to RAM (STR)
or normal. Although the values are not predefined, red usually
indicates STR and green indicates normal.
JP17: USB2 power on jumper
Use this jumper to enable a signal to the USB devices 3 and 4
(located on the front panel) to wake up the system from power
saving mode.
Function
Disable
Enable
JP18: BIOS Flash protect jumper
Use this jumper to enable or disable the BIOS flash protection
on the mainboard. You should disable this jumper when you
want to flash the BIOS.
Function
Disable
Enable
Jumper Setting
Short pins 1-2
Short pins 2-3
1
Jumper Setting
Short pins 1-2
1
Short pins 2-3
Jumper Setting
Short pins 1-2
1
Short pins 2-3
16
JP8
2 3
JP17
2 3
JP18
2 3