Knoll VIS Install Manual

VIS Infrared Receiver Specifications:

Specifications
Infrared carrier frequency: 30-60kHz
Indoor reception range:
Nominal reception angle:
Maximum wire length:
Wire requirements:
Power requirements:
Dimensions:
Requires 12VDC power supply, emitter(s) and IR54, or
IR55 connection block.

Warranty

Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state-to-state.
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond BC V7A 4V4
Telephone: (604) 272-4555, Fax: (604) 272-5595
Made in Canada Knoll Systems All Rights Reserved
20-25 feet (6-8 meters)
50 degrees off axis
1000' (300m) or more with larger
gauge wire
3 conductors, minimum 24-gauge
to 200'; 22-gauge up to 500';
20-gauge to 1000'
Unregulated 12VDC, 40mA
1-3/4" x 4" x 1"
(45mm x 102mm x 26mm)
VIS
Infrared Receiver on Knoll Stereo
Volume Controls
Installation Instructions v1.0
Warning: To be installed and/or used in accordance with
appropriate electrical codes and regulations.

Introduction:

Thank you for your purchasing another Knoll
product! The VIS module is an infrared receiver that is mounted
on one of our volume controls. It does not directly control the
volume control. Follow the volume control installation directions
shipped with this product. This receiver features the ability to
pick up a remote control infrared signal from up to 25 feet away
and relay it on wires to another location up to 1000' (or more).

Features:

• Inwall junction box
design available in
ivory, almond and black
colors.
• Will relay almost all
remote control types
(except some B & O
models).
• Can be connected with
almost any 3-conductor
wire including cat 5.
• Requires very little
power. Suggest using
PS1202 12 VDC (200
mA) for up to 5 IR21s.
• Up to 10 IR10's, IR21's
IR25's and other compatible models can be connected
in a single system.
• Connects with a three wire connector or RJ45 via cat 5
wire.
white,
Bl ue
talkback
LED
volume
knob
IR
Receiver