It is considered improper use when the product is used for any application not named in the corresponding instruction manual. Sennheiser does not accept liability for damage arising from improper use or misuse of this product and its attachments/accessories. Before putting the products into operation, please observe the respective...
The MKE 600 shotgun microphone The MKE 600 is the ideal video camera/camcorder microphone able to hand- le even demanding filmic challenges. Due to its high directivity, the MKE 600 picks up sounds coming from the direction in which the camera is pointing and effectively attenuates noise coming from the sides and rear.
Foam windshield attenuates wind noise by approx. 25 dB “Low Cut” switch LED operation indicator 4 BATT ON/OFF battery switch Lower part of the microphone body (covers the battery compartment) XLR-3 socket (male) Shock mount with flash mount adapter MKE 600...
Page 5
Putting the MKE 600 into operation The MKE 600 offers a choice of phantom powering via the XLR connection or internal battery powering. P48 phantom powering via XLR connection f Connect the XLR-3 socket (female) of the microphone cable to the XLR-3 socket (male) of the microphone 8.
Page 6
„Low Cut“ verwenden f Set the “Low Cut” switch to the desired position. Switch position Frequency response of the microphone linear frequency response frequencies below 100 Hz are attenuated to reduce wind and impact noise MKE 600...
Cleaning and maintaining the MKE 600 CAUTION DAMAGE TO THE PRODUCT DUE TO LIQUIDS! Liquids entering the product can short-circuit the electronics or damage the mechanics. Solvents or cleansing agents can damage the surface of the pro- duct. f Keep all liquids away from the product.
Need help?
Do you have a question about the MKE 600 and is the answer not in the manual?
Questions and answers