Specifications; General Technical Specifications - Honeywell E3Point User Manual

Specifications

General Technical Specifications

Uses
Size
Electrical
Ratings
Sensor Types
and Operating
Parameters
Outputs
Display
Visual
Indicators
Audible Alarm
32
Specifications
Standalone duct or wall mounted gas monitor with optional additional
Remote monitor.
Network duct or wall mounted gas monitor. Communicates with 301C
(or AA96D) at 9600 Baud.
Standalone/Network monitor (H x W x D): 20.56 x 14.90 x 6.72 cm
(8.09 x 5.87 x 2.65")
Remote monitor (H x W x D): 3.5 x 4.5 x 6.5 cm (1.36 x 1.75 x 2.56")
38 g (1.34 oz)
Standalone/Network monitor
24 Vac, 350mA, 60 Hz
24 Vdc, 350 mA
E3SAH only: 120 Vac, 75 mA
Electro-Chemical – (CO, NO
Catalytic Bead – (CH
Indoor use, Maximum altitude: 2000 M, 15 – 80% RH
Response time: T90 < 50 seconds;
Response time with ECLAB (water shield): T90 < 240 seconds
All sensors except CO: -40 to 50°C (-40 to 122°F)
CO: -20 to 50°C (-4 to 122°F)
CO for UL 2075: 15 - 35°C (59 - 95°F)
Standalone monitor
2 DPDT relays, 5 A @ 250 Vac
and 30 Vdc, 4-20 mA
Remote monitor – Provides MODbus signal back to Standalone
monitor for processing. 4-20 mA output not available for Remote
monitor. OUT1 and OUT2 are not used.
Standalone/Network monitor – 8 character, 2 line backlit LCD
Standalone monitor
Green LED: Power
Amber LED 1: Alarm/Fault
Amber LED 2: Alarm/Fault
Remote monitor – Amber LED: Transmission
Standalone/Network monitor - > 85 dBA at 3 m (10 ft)
Remote monitor: Class 2 or
limited power source (lps) only.
Electro-Chem Sensor: 10 - 24 Vdc,
50 mA
Catalytic Bead Sensor: 10 - 16 Vdc,
100 mA
, H S, O );
2 2 2
, H C H )
4 2 3 8
Network monitor
1 DPDT relay, 5 A @ 250 Vac
and 30 Vdc
MODbus and BACnet MS/TP
master
Network monitor
Green LED: Power
Amber LED 1: Alarm/Fault
Amber LED 2: Transmission
E Point Gas Monitor Technical Manual
3