Table of Contents
Advertisement
16
www.aeg.com
Cooker hoods with the Hob²Hood
function
To find the full range of cooker hoods
which work with this function refer to our
8. CARE AND CLEANING
WARNING!
Refer to Safety chapters.
8.1 General information
• Clean the hob after each use.
• Always use cookware with a clean
base.
• Scratches or dark stains on the
surface have no effect on how the hob
operates.
• Use a special cleaner suitable for the
surface of the hob.
• Use a special scraper for the glass.
8.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
You cannot activate or oper‐
ate the hob.
consumer website. The AEG cooker
hoods that work with this function must
have the symbol
otherwise, the dirt can cause damage
to the hob. Take care to avoid burns.
Use a special hob scraper on the
glass surface at an acute angle and
move the blade on the surface.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and a non-abrasive
detergent. After cleaning, wipe the
hob dry with a soft cloth.
• Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You do not set the heat set‐
ting for 50 seconds.
.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 50 seconds.
Advertisement
Table of Contents
