Changing The Activated Charcoal Filter (Only In Circulating-Air Mode); Resetting The Saturation Indicator - Gaggenau VL 414 712 Use And Care Manual

en-us
Cleaning and maintenance
Cleaning in the dishwasher
Note: Slight discoloration may occur if cleaning in the
dishwasher. This has no effect on the performance of the
metal grease filter.
1.
Place the metal grease filters loosely in the
dishwasher with the opening facing down. Do not jam
in the metal grease filters.
2.
Do not clean heavily soiled metal grease filters
together with tableware.
Cleaning by hand
1.
Soak the metal grease filter in hot soapy water.
2.
Clean with a brush and then rinse thoroughly.
3.
Allow the metal grease filter to dry before inserting.
Note: You can use a special degreaser to remove
stubborn dirt. It can be ordered via the online shop.
Changing the activated charcoal filter
(only in circulating-air mode)
Activated charcoal filters trap the odor-causing
compounds from cooking smells. They are only used for
air-recirculation mode.
The activated charcoal filter of the remote fan unit must
be replaced at regular intervals. The saturation indicator
on your appliance tells you how frequently this needs to
be done.

Resetting the saturation indicator

If the saturation indicator for the metal grease filter or
activated charcoal filter has flashed, you must reset the
saturation indicator after cleaning or changing the filter.
1.
Push in the control knob and turn it clockwise to the
œ position.
2.
The illuminated ring behind the control knob lights up
white and goes out for approx. five seconds and lights
up white again.
The saturation indicator is reset.
3.
Turn the control knob back to position 0.
26