Standard Power Cords - Cisco MDS 9124V-K9 Hardware Installation Manual

Standard Power Cords

Caution
Standard Power Cords
Cisco standard power cords for the switch, have an IEC C15 connector on the outlet end of the cord, and a
country specific plug on the inlet end of the cord.
The following table lists the supported power cords and power plugs for the switch.
Table 13: Supported Power Cords and Power Plugs
Locale
Argentina
Australia
China
Europe
Israel
Italy
Korea
Cisco MDS 9124V-K9 Switch Hardware Installation Guide
52
If you do not order a power cord with the system, you are responsible for selecting the appropriate power cord
for the product. Using a noncompatible power cord with this product may result in electrical safety hazard.
Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with the
system.
Power Cord Part
Number
CAB-9K10A-AR
CAB-9K10A-AU
CAB-9K10A-CH
CAB-9K10A-EU
CAB-9K10A-ISR
CAB-9K10A-IT
CAB-9K10A-KOR
Source Plug Length
Type
IRAM 2073 plug 8.2 ft (2.5 m)
(10 A)
SAA/3 plug, AS 8.2 ft (2.5 m)
3112-1993 (10
A)
GB1002 (10A) 8.2 ft (2.5 m)
VIIG Plug, CEE 8.2 ft (2.5 m)
(7) VII (16 A)
SI 32 Part 1.01 14 ft (4.27 m)
(16A)
1/3G plug, CEI 8.2 ft (2.5 m)
23-16 (10 A)
CEE 7 Standard 8.2 ft (2.5 m)
Sheet VII (16A)
Cable and Port Specifications
Power Plug Reference
Illustration