Standard Power Cords; Jumper Power Cord; Fibre Cable Specifications - Cisco MDS 9148T Hardware Installation Manual

Standard Power Cords

Caution
If you do not order a power cord with the system, you are responsible for selecting the appropriate power cord
for the product. Using a noncompatible power cord with this product may result in electrical safety hazard.
Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with the
system.
Standard Power Cords
Cisco standard power cords for the Cisco MDS 9148T switch have an IEC C15 connector on the outlet end
of the cord and a country specific plug on the inlet end of the cord. To see the list of supported standard power
cords, see the

Jumper Power Cord

Jumper power cords have an IEC C15 connector on the outlet end of the cord and an IEC C14 connector on
the inlet end of the cord. This cord is compatible with IEC C13 outlet receptacles. This type of outlet receptacle
is commonly used for power distribution inside cabinets.
To see the list of supported jumper power cords, see the
Switch Data

Fibre Cable Specifications

For information on the fibre cable specifications, see the
Data
Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel Switch Hardware Installation Guide
60
Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel Switch Data
Sheet.
Sheet.
Cable and Port Specifications
Sheet.
Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel
Cisco MDS 9000 Family Pluggable Transceivers