Prolight DC20 User Manual page 77

• Select the scene to play with the + and – buttons on top of the box.
Note:
• You must connect an interface with the stand alone function (hardware memory) to activate the stand
alone functions of the software.
• You can choose the interface to program because it is possible to connect until 6 interfaces and manage
3072 dmx channels.
• You will loose the memory content as soon as you write in the memory some new scenes. Don't loose the
previous content of your memory if you need it.
• Stand alone mode allow you to play only 1 scene. The order of the scenes played will respect the position
of the memory map and the Jump information of each scene.
• When you power on the interface, it will always play the first scene of the list.
8.4 External contact I/O of the stand alone interfaces
A stand alone interface can control 512 channels and can trigger 8 scene directly with its external HE10
connector. The HE10 allow you to connect an external switch control (8 buttons with 8 contacts). With the
HE10, it is possible to synchronize several interfaces in stand alone mode. So you can manage several DMX
universes without computer. The software can load the scenes into several interfaces. With a specific con-
nection on each HE10 connectors, each buttons or contact can trigger a scene of each interfaces and syn-
chronize the DMX universes. This is the scheme of the external switch control that you can use to activate
some scenes.
It is also possible to use the functions below from the internal HE10 connector of the interface.
• Pin1: Ground
• Pin2: Ground
• Pin3: DMX+
• Pin4: Pulsante-
• Pin5: DMX-
• Pin6: Pulsante+
• Pin7: +3V3
• Pin8: 'DMX'Led
• Pin9: V.EXT
• Pin10: '#' Led
8.5 Features of the Stand alone interface
• A maximum of 512 stand alone channels (only 60 for the economic interface).
• 16000 steps of memory capacity (only 230 steps with 512 channels and 50 steps with the economic 60
channels interface).
DC20 - DC21 - DC22
35