Table of Contents
Advertisement
Climate Trak / Heat Transfer Plate System Installation
4.5 Installing the Tubing
16 of 40
Begin to make non-stressful (teardrop) type loops for each of the bays,
keeping loops small and manageable.
Continue making the "teardrop" loops, being sure not to install any of
the tubing into the Traks yet. Keep loops fairly small and manageable to
prevent twisting while keeping the loops easy to transfer tubing through.
Transfer tubing from the decoiler through loops until there is enough
tubing to fill the final bay and make the run back to the manifold using the
second set of drilled holes.
Once the final bay is installed, transfer tubing from coil to fill next bay and
so on.
Tubing can be installed into Traks using a rubber mallet or
a palm hammer with a medium plastic tip.
IM-HC 530590 0621 Climate Trak (EN)
Advertisement
Table of Contents
