Returning The Stored Vehicle To Service - Husqvarna HUV4420 Service Manual

Gasoline/diesel vehicles
Hide thumbs Also See for HUV4420:
Table of Contents

Advertisement

GENERAL INFORMATION
6.1. Fill the fuel tank with fresh fuel.
6.2. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 3-3, Page 3-3).
6.3. Plug the fuel tank vent nipple so that it is air tight. Husqvarna recommends using a slip-on vinyl cap.
7. Change engine oil. See Engine Oil and Filter Change on page 10-7.
All vehicles:
8. Disconnect the battery cables, negative (–) cable first. See WARNING "To avoid unintentionally start-
ing..." in Section 1 – Safety on page 1-2.
9. Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of
baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off bat-
teries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry
and then coat them with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
10. Adjust the tires to the recommended tire pressure. See Section 8 – Wheels and Tires.
11. Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 10-4.
12. Thoroughly clean the front body, rear body, seats, cargo bed, engine compartment, and underside of
vehicle.
13. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
TO FUEL FILTER
FUEL TANK
Figure 3-2 Fuel Tank – Gasoline Vehicles

RETURNING THE STORED VEHICLE TO SERVICE

1. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL
position. Chock the wheels.
2. Restore the fuel system to operation (Figure 3-2, Page 3-3 or Figure 3-3, Page 3-3).
2.1. Remove the plug from the fuel tank vent.
2.2. Connect the vent tube to the fuel tank vent.
3. Connect the battery cables, positive (+) cable first, and tighten the terminals to 12 ft-lb (16 N·m). Coat ter-
minals with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
4. Gasoline vehicles only: Completely open the fuel shut-off valve (Figure 3-4, Page 3-4). Ensure that
the valve is fully open. A partially closed fuel shut-off valve combined with the use of the choke can result
in a fouled spark plug and engine failure (Figure 3-6, Page 3-4).
2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual
FUEL SHUT-OFF
VALVE
VENT
TO FUEL FILTER
FUEL TANK
Figure 3-3 Fuel Tank – Diesel Vehicles
3
Storage
VENT
Page 3-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Huv4420-d

Table of Contents