Safety Belt Removal; Safety Belt Installation - Husqvarna HUV4420 Service Manual

4
BODY AND TRIM
SAFETY BELTS
See General Warning, Section 1, Page 1-1.
ý
CAUT ION
• Be careful not to damage the safety belt webbing or hardware.
• Inspect the safety belt system periodically. Check for cuts, fraying, and loose parts. Replace
damaged parts immediately. Do not disassemble or modify the system.
• Keep safety belts clean and dry. If cleaning is necessary, use a solution of mild soap and
lukewarm water. Do not use bleach, dye, or abrasive cleaners as they may severely weaken
the safety belts.
• Do not insert coins, clips, etc. into the safety belt buckle. Foreign objects may interfere with
the buckle locking mechanism.
• If the safety belt does not function normally, contact your Husqvarna dealer/distributor or
trained technician immediately. Do not occupy the seat until the safety belt is repaired.

SAFETY BELT REMOVAL

1. Remove the bolt from the base of the coiled safety belt assembly (outside location) (Figure 4-5,
Page 4-8).
2. Remove the coiled safety belt assembly.
3. Remove the bolt from the center safety belt latch base assembly (center location) (Figure 4-6,
Page 4-8).
4. Remove the safety belt latch base assembly.
Figure 4-5 Coiled Seat Belt Assembly

SAFETY BELT INSTALLATION

1. Install the center safety belt latch base assembly to the center of the ROPS seat frame with a new thread-
forming bolt. Orient the assembly with the latch end pointed up slightly, and tighten the hardware to 55 ft-
lb (75 N·m).
Page 4-8 2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual
Figure 4-6 Center Seat Belt Fastener
Safety Belts