Sony HT-NT3 Service Manual page 66

HT-NT3
Pin No. Pin Name
AG14 RDQ0
AG16 RDQS0
AG17 RCLK0
AG18 RDQS1_
AG19,
RDQ7, RDQ4
AG20
AG21 to
NFD7, NFD4, NFD2
AG23
AG25 GPIO8
AG26 VCLK
AG27 VDATA
AG28 LCDRD
RDQ18, RDQ19,
AH1 to AH3
RDQ24
AH4 RDQM3
AH5 RDQS2_
AH6 RCLK1_
AH7 RDQS3
AH8 RDQ23
AH10,
RA0, RA7
AH11
AH13 RCKE
AH14 RDQ2
AH16 RDQS0_
AH17 RCLK0_
AH18 RDQS1
AH19 RDQM0
AH20 RDQ6
AH22,
NFD5, NFD3
AH23
AH25 OPWRSB
AH26 UATXD
AH27 VSTB
AH28 IR
66
I/O
I/O Two-way data bus with the SD-RAM
O Data strobe signal (positive) output to the SD-RAM
O Clock signal (positive) output to the SD-RAM
O Data strobe signal (negative) output to the SD-RAM
I/O Two-way data bus with the SD-RAM
I/O Two-way data bus with the NAND fl ash
O VBUS on/off control signal output terminal for WLAN/BT COMBO card "H": VBUS on
O Serial data transfer clock signal output to the system controller
I Serial data input from the system controller
O Serial data output to the system controller
I/O Two-way data bus with the SD-RAM
O Data mask signal output to the SD-RAM
O Data strobe signal (negative) output to the SD-RAM
O Clock signal (negative) output to the SD-RAM
O Data strobe signal (positive) output to the SD-RAM
I/O Two-way data bus with the SD-RAM
O Address signal output to the SD-RAM
O Clock enable signal output to the SD-RAM
I/O Two-way data bus with the SD-RAM
O Data strobe signal (negative) output to the SD-RAM
O Clock signal (negative) output to the SD-RAM
O Data strobe signal (positive) output to the SD-RAM
O Data mask signal output to the SD-RAM
I/O Two-way data bus with the SD-RAM
I/O Two-way data bus with the NAND fl ash
O Power control signal output to the system controller
- Not used
- Not used
- Not used
Description