Using Multi Operations; Using System Off - Pioneer Elite VSX-81TXV-S Operating Instructions Manual

Controlling the rest of your system
11
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be
selected:
RECEIVER
INPUT
SELECT
CD
DVD TV
CD-R/TAPE HDMI2
iPod HDMI1
SLEEP
SR+
DIALOG E
D.ACCESS
+10
AV PARAMETER
TOP MENU
TUNE
DTV MENU
ST
SETUP
TUNE
CATEGORY
GUIDE
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
9 When you're finished, use
from the menu and press ENTER .
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
68
En
SYSTEM OFF
SOURCE
TV CONTROL
INPUT
TV VOL TV CH VOL
SELECT
DVR 2
DVR1 TV CTRL
XM RADIO ROOM 2
DTV ON/OFF REC DTV INFO
TUNER RECEIVER
MUTE
MPX REC STOP JUKEBOX
VIDEO ANALOG
SEL ATT
AUDIO SUBTITLE HDD DVD
MIDNIGHT/
DIMMER
DISP CH CH
LOUDNESS
STATUS SIGNAL SEL SBch STEREO
S.RETRIEVER
MULTI OPE THX STANDARD ADV.SURR
CLASS
DISC
ENTER
SHIFT PHASE
MCACC S.DIRECT
CH LEVEL
MENU
T.EDIT
ST
ENTER
RETURN
RECEIVER
BAND
to select EDITEXIT

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
AUDIO SUBTITLE
DISP
STATUS SIGNAL SEL
MULTI OPE THX
SHIFT PHASE
RECEIVER
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.

Using System off

SYSTEM OFF
RECEIVER INPUT SOURCE
SELECT
CD DVR 2
DVD TV DVR1 TV CTRL
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press SOURCE .
The command sequence you programmed will run, then
all Pioneer components will switch off
receiver.
HDD DVD
CH CH
SBch STEREO
STANDARD ADV.SURR
MCACC S.DIRECT
AUDIO SUBTITLE HDD DVD
DISP
CH CH
STATUS SIGNAL SEL SBch STEREO
MULTI OPE THX
STANDARD ADV.SURR
SHIFT
PHASE MCACC S.DIRECT
RECEIVER
1
, followed by this