Table 8-13 Wan Parameters - Route Mode; Figure 8-16 Wan Page - Route Mode - Nokia ONT Product Manual

Configure a G-2426G-B indoor ONT
Network configuration
Configuring WAN

Figure 8-16 WAN page - Route Mode

2
Configure the following parameters for a specific WAN connection.
Table 8-13, "WAN parameters - Route mode" (p. 123)
window for Route Mode

Table 8-13 WAN parameters - Route mode

Field
WAN Connection List
Connection Type
Connection mode
IP mode
Enable/Disable
NAT
June 2021
Issue 1
Description
Select a WAN connection from the list to set the connection parameters.
Select a connection type: IPoE or PPPoE.
This option is only available for the operator ID MSNA, and for some operator-specific operator
IDs.
Choose a connection mode: Route Mode or Bridge Mode. The default is Route Mode.
If you select Bridge Mode, see
"WAN network parameters—Bridge Mode" (p. 125)
Select an IP mode from the list: IPv4 or IPv6.
Select this checkbox to enable the WAN connection.
Select this checkbox to enable NAT.
3FE-49441-ABAA-TCZZA
describes the fields in the WAN network
Figure 8-17, "WAN page - Bridge Mode" (p. 124)
Nokia ONT
and Table 8-14,
123