Page 1
Operation and Maintenance Manual Enerpac CULP High Tonnage Ultra Flat Cylinders Document Number: L4213 Document Revision: H Document Revision Date: 07-2022 Document Language: ENGLISH EN To reduce the risk of injury, user must read and understand this document before use.
Page 3
Enerpac for quality tools, services and solutions. For additional information, visit www.enerpac.com. WARRANTY Refer to the Enerpac Global Warranty document for terms and conditions of the product warranty. Such warranty information can be found at www.enerpac.com. NAMEPLATES L4213_h...
In the event that any questions or within the procedures of this manual. concerns arise, contact Enerpac or a local Enerpac distributor for clarification. • Operating procedures will vary, depending on the system arrangement.
• Do not use the cylinder to lift people. Do not allow to fit properly and to withstand high loads. Non- people to be on top of the load during lifting or Enerpac parts may break or cause the product to lowering. malfunction.
Features & Components 2.3 Feature Diagram 1. Plunger 2. Stop Ring 3. Cylinder Base 4. Female coupler 5. Dust Cap (Only on CULP100) 6. Lifting Eye (Only on CULP100) Figure 1: Major features and components of CULP cylinders NOTE: CULP100 cylinder shown in the picture L4213_h...
Hydraulic pumps are sold separately and are not included with the cylinders. A hand-operated hydraulic Enerpac CULP Series hydraulic cylinders are an ideal pump can be used to operate a CULP-Series cylinder. solution for a wide variety of lifting and industrial...
Repeat steps 3 and 4 until the plunger advances 4.2 Hydraulic Oil Requirements smoothly. Use of Enerpac HF Series ISO 32 hydraulic oil is Be sure that the plunger is fully retracted. Then, recommended. Enerpac HF oil is available at your local check the oil level in the pump hydraulic reservoir.
Keep stored cylinders and hoses away from heat and direct sunlight. 5.1 Operating Precautions If repairs are required, refer to the Enerpac website for WARNING the repair parts sheet applicable to your cylinder model Failure to observe the following instructions and...
For repair service, contact your nearest Enerpac Authorized Service Center. As required, also refer to the troubleshooting information provided with your hydraulic pump or power unit.
Need help?
Do you have a question about the CULP10 and is the answer not in the manual?
Questions and answers